Parker's PGP500 family — aluminum bushing-block gear pumps with a two-piece cast design — is built specifically for cost-sensitive, high-power-density applications where forklifts sit alongside agriculture and turf equipment as named target markets. Compared to Parker's heavier cast-iron 300/600 series used in construction equipment, the PGP505/511 is lighter and more compact, matched to a forklift's typical mast lift and tilt demands.
Where a Parker Pump Fits Your Forklift
Forklift shipped with Parker as OEMDirect genuine-spec replacementExact PGP model from nameplate
OEM pump expensive or long lead timeComparable pressure/flow, widely stockedMounting flange & port pattern
Fleet standardisation across brandsOne pump family across multiple forklift makesDisplacement rating for your mast size
WhatsApp a photo of your current pump's nameplate — we confirm the correct PGP match before you order.
Parker PGP505 aluminum gear pump — refurbished, flow tested, ready for material handling duty
What Our Refurbishment Covers
Gear Set & Bushing BlocksMeasured against Parker tolerance — the aluminum bushing-block design is inspected for wear that would reduce output.
Shaft SealReplaced as standard on every unit — the most common external leak source.
Thrust Plates & Seal ConfigurationChecked and renewed to restore performance under repeated pressure cycling.
All O-rings and GasketsRenewed on every unit before reassembly.
Flow Test at Rated RPMActual output measured and documented in the written test report before dispatch.
Why Warehouse & Fleet Operators Choose PumpGrid
Faster Than OEM Dealer Channels
Genuine PGP-series pumps for specific forklift brands can carry multi-week dealer lead times in India. PumpGrid dispatches tested refurbished units in 2-3 working days.
40-60% Savings vs New OEM
Because the PGP500 series is designed for cost-sensitive applications, refurbishment pricing stays low without sacrificing tested performance.
Fit Confirmed Before You Order
We check mounting flange, spline, and displacement against your specific forklift before the pump ships — not after.
3-Month Warranty on Every Unit
Confirmed in writing, with replacement rather than repair for any refurbishment defect within warranty.
Forklift Pump Warning Signs
Mast lifting slowly or stopping before full height
Side-shift or tilt sluggish
Whining or grinding sound on control operation
Load drifting down slowly under its own weight
Oil puddle under the rear of the forklift
Hydraulic fluid getting hot during a normal shift
If 2 or more of the above apply, the pump likely needs refurbishment. WhatsApp us the machine model and symptoms.
We Supply Across India
FAQs
Is Parker the OEM pump on my forklift, or would it be an aftermarket substitute?
It depends on your forklift brand — some manufacturers fit Parker PGP-series pumps as original equipment, while on others it's a well-matched aftermarket alternative. Check your current pump's nameplate; if it already says Parker, you have a genuine-spec replacement option. If not, we'll confirm whether a PGP unit is a suitable substitute for your machine.
What's the difference between the PGP500 series and Parker's other gear pump lines?
The PGP500 (aluminum, bushing-block design) is built for lighter-duty, cost-sensitive applications like forklifts, turf, and agriculture. Parker's PGP300/600 series (cast iron, heavier duty) targets construction equipment like tippers and dozers. Using the correct series matters for both fit and expected service life.
Can you supply for a mixed-brand forklift fleet?
Yes — one advantage of standardising on Parker PGP pumps is that a single pump family can often serve multiple forklift brands in your fleet, simplifying spares inventory. WhatsApp us your fleet list and we'll map out compatibility.
Related Pages